molecularbob   10 #1 Posted June 22, 2021 (edited) Hi All  I have an aluminum gearbox spacer, about 12cm diameter that is slightly too tall. It needs ~ 3mm milling off to be at the correct height for my clutch set up. Will have accurate numbers when i can find my vernier.  Can someone recommend a light engineering company that can turn around a one off in a reasonable time frame and cost?  Thanks  Ian B. Edited June 22, 2021 by molecularbob Spelling Share this post Link to post Share on other sites Share this content via...
rudds1   102 #2 Posted June 22, 2021 23 minutes ago, molecularbob said: Hi All  I have an aluminum gearbox spacer, about 12cm diameter that is slightly too tall. It needs ~ 3mm milling off to be at the correct height for my clutch set up. Will have accurate numbers when i can find my vernier.  Can someone recommend a light engineering company that can turn around a one off in a reasonable time frame and cost?  Thanks  Ian B. Try Sheffield engine services. At catch bar lane.   Share this post Link to post Share on other sites Share this content via...
ianparkin   11 #3 Posted June 22, 2021 I can do it you quick whilst you wait in nether edge Share this post Link to post Share on other sites Share this content via...
molecularbob   10 #4 Posted June 23, 2021 Hi Ian  That would be great. Could you message me some contact details and I will get back to you once I have my measurements. It will need to be milled not lathed I think as it has a cutout on one edge to clear a stub shaft. Share this post Link to post Share on other sites Share this content via...