Jump to content

Marble worktop repair


Recommended Posts

Not sure if this is the right section for this query but i hope someone can help. We have a black marble kitchen work surface with a crack all the way through. I understand there are marble epoxy resins which can be coloured to match which can do the job. Does anyone know if this is correct and if so where i can get the stuff from. The stone merchants i have asked just say buy a new one but the cost is prohibitive.

Link to comment
Share on other sites

a standard epoxy resin would do a fine job as it doesn't have any colour so shouldn't cause an issue as long as the crack isn't too big, failing that again as long as the crack isn't too big a coloured silicone would be an ideal gap filler is its flexible, try a tile shop for a good range of coloured silicones

Link to comment
Share on other sites

  • 1 month later...

With time, the problem often comes with marble worktops.

 

I have researched for it, and found some good tips for you to solve out this problem. Please go through it below, Hope this will work for you.

 

Marble is a delicate stone that can become damaged fairly easily but have no fear as you can repair a marble floor without spending thousands. A marble floor is very expensive and replacing it isn't in the cards or the budget. The only recourse you can take is to repair the marble floor by patching any chips or chunks from the marble. It seems much harder than it actually is and the article below will show you how to do easily repair the marble floor.

 

Step 1 – Marble Floor Surface Preparation

 

Since the marble floor is already chipped this means you do not have to remove the finish like you would to repair scratches. You do not even have to wipe down the floor. There is some minimal preparation to consider though as you are still left with a hole in your expensive marble floor. Inside the hole will most likely be loose marble which will need to be removed in order to make the patch adhere. Use the brush to dust out the bits of rock in the hole as well as to remove any loose pieces from the hole of the site. Use the miniature vacuum to suck up the debris. Use the tack cloth to remove the dust away from the perimeter of the hole.

 

Step 2 – Replace the Chunk

 

If the chunk of marble still remains then you may be in luck. Marble does not usually crumble and depending on how the hole was made you will be able replace it. When you want to repair a marble floor in this manner you will need to use adhesive formulated for marble or stone. Apply some of the adhesive to the hole and some to the piece then place it inside the hole. Press down and wipe away any excess adhesive.

 

Step 3 – Filling a Hole

 

This is the easiest method to repair a marble floor that has a chunk taken out of it and is missing. Make sure that the hole has been full cleaned and prepared prior to filling the hole with epoxy. Use an epoxy that comes in two parts and mix them in a clean bowl according to the directions. You will have to work quickly before the epoxy starts to set. Spoon the epoxy into the hole with the spoon until it overflows the edges. Use the putty knife to spread the epoxy out and this will also push the epoxy all the way inside the hole. Wet down a rag and remove the excess water and use it to wipe around the edges of the hole. This will remove the excess epoxy so that the edges are flush to the marble floor.

 

Step 4 – Finishing Up

 

After the epoxy has cured you can seal the spot using polyurethane. Pour a very small amount of polyurethane in a plastic bowl. Apply it over the epoxy using the micro brush.

Link to comment
Share on other sites

  • 2 weeks later...
  • 3 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...

Important Information

We have placed cookies on your device to help make this website better. You can adjust your cookie settings, otherwise we'll assume you're okay to continue.