Greenveg   10 #1 Posted November 8, 2018 Hi, I have a Veritas 8 Compact house alarm, and I would like to permanently disable one of the zones, so that I do not have to do it every night. I have the engineers code. Regards.  ---------- Post added 08-11-2018 at 17:23 ----------  I want to disable zone 2, which is in my hall. I live in a bungalow. I would appreciate which numbers to press, step by step. Share this post Link to post Share on other sites Share this content via...
alarmingmark   32 #2 Posted November 8, 2018 Make the zone off in part , then at night press part instead of full , eng code , prog , 51 , zone number you want off in part , prog , reset , reset Share this post Link to post Share on other sites Share this content via...
Greenveg   10 #3 Posted November 8, 2018 Do I need to do this every night. What I want to do is disable the zone permanently, so at night I only need to press the "Full" button which alarms the system. I need the hall to not be alarmed during the night, and I do not want to have to go through the omit zone routine every night. I hope that this makes sense. I am an elderly person. Share this post Link to post Share on other sites Share this content via...
alarmingmark   32 #4 Posted November 8, 2018 Enter code and part , what zones flash on the panel ? Share this post Link to post Share on other sites Share this content via...
Greenveg   10 #5 Posted November 8, 2018 Zone 2, which is the zone I want to disable. Share this post Link to post Share on other sites Share this content via...
alarmingmark   32 #6 Posted November 9, 2018 So just press code and part at night ( it may make a quieter clicking noise ) this is normal for part set or it may be silent ( all depends on how it has been programmed ) Share this post Link to post Share on other sites Share this content via...
willman   10 #7 Posted November 9, 2018 Would it not be easier to remove the detector permenantly for that area. If its a safety concern could it be repositioned. Share this post Link to post Share on other sites Share this content via...
alarmingmark   32 #8 Posted November 9, 2018 Unfortunately I don't know layout of the property , what devices are fitted , how it's been programmed ect....ect ... but it looks as if it's been set up for hall off in part set so why change it ? Share this post Link to post Share on other sites Share this content via...
willman   10 #9 Posted November 9, 2018 I think its for ease and convenience if i understand the op. They want to simply press set and that zone remain inactive.  Which i think is what you described in #2. But they press PART and not FULL iirc. Share this post Link to post Share on other sites Share this content via...
Greenveg   10 #10 Posted November 9, 2018 (edited) I rang the local company who fitted the system, and he went through the routine over the phone. He told me to enter the engineers code, then 51. He then went through a couple of numbers, I think 21 and 12. The result is that when I leave the house, I press the Full button to alarm the system. At night, I only need to press the PART button, no code needed. As you previously stated, this makes a quiet clicking sound. Zone 2 is then omitted. I would like to thank you all for your help and advice. Regards. Edited November 9, 2018 by Greenveg spelling Share this post Link to post Share on other sites Share this content via...